Description
16 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9093 and MSPNP-MM9495 for extra inputs and outputs. Can also be used with DIYPNPN76-K, DIYBOB-N76K, or to repair a factory wiring harnesses.
Weatherpack style connector for GM boost control solenoid. This connector comes with crimp-on pins to keep the number of splices in your wiring harness to a minimum. Note: This connector is not needed for our newer style (12/2008 and newer) non-GM EBC ...
Add to cartThis electronic boost control solenoid can be used with the MS3-Pro/MSPNP as well as any DIY Style MegaSquirt EMS (with the appropriate mods), or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. Th...
Add to cartMany older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cartGM Style 3-pin TPS Pigtail used in many GM applications, as well as others.... 6" Pigtail, pre-crimped, ready for your harness.
Add to cartIncluded is an 8' long harness for installing the MicroSquirt on larger vehicles instead of motorcycles and ATVs. Serial cable included.
Add to cartDB26 pigtail connector, as used with the latest MSPNP Gen 2 for its 26 pin expansion connector. Includes 6" pre crimped wires. Poke in the ones you need, leave out the ones you don't.
Add to cart
1 review for MSPNP 16 Pin Center Connector