Description
TPS-3 Connector (Uncrimped)
GM Style 3-pin TPS Connector complete with:
- the 3-pin connector
- three pins
- plus an extra fourth pin (just in case)
$6.49
-
TPS-3 Connector (Uncrimped)
GM Style 3-pin TPS Connector complete with:
There are no questions yet, be the first to ask something for this product.
Need a weld-free way to add EGT fittings to a cast iron manifold? Drill and tap it for 1/8" NPT pipe thread and bolt one of these in! Works with our Red Avenger and Black Stinger thermocouples.
Add to cartThe CANEGT 8 Channel Thermocouple Interface allows you to monitor up to 8 K-type thermocouples AND up to 8 Innovate wideband devices over an Innovate Log Chain, and can transmit the data to a MegaSquirt-II, MegaSquirt-III, MicroSquirt, MSPNP, or MS3Pro o...
Read moreConvert your Nissan CAS to a more MegaSquirt-friendly arrangement with our bolt in optical shutter wheel! This replaces the stock low-resolution Nissan trigger wheel that has four slits with a higher resolution 24-2 wheel crank trigger. Intended for use ...
Add to cartDL32 Datalogger and Sensor Controller The DL-32 is a complete vehicle-mounted data-logging system for advanced engine tuning. The system is anchored by Innovate's award-winning digital wideband air/fuel ratio technology, but also includes flexible sens...
Read moreGot a stainless steel exhaust? Here's what you need to install an EGT probe in it. Weld this compression fitting into your headers or exhaust pipe. It holds a EGT probe securely in place. Compression type fitting provides a leak-free seal that holds up at...
Add to cartRemoving your EGT probes? Seal the hole with these cap kits. Note: These will not fit our thread in fittings (EGT_0004). If using the thread in fittings, you will need to unscrew the fitting and replace with a 1/8" NPT pipe plug instead. They will fit ...
Add to cart
Reviews
There are no reviews yet.