Description
TO-220 heat sink as used on coil drivers for the DIYPNP. V1.1 DIYPNPs also used these for the voltage regulator, boost control, and a few other functions.
$2.00
-
TO-220 heat sink as used on coil drivers for the DIYPNP. V1.1 DIYPNPs also used these for the voltage regulator, boost control, and a few other functions.
There are no questions yet, be the first to ask something for this product.
Replacement CP-102A-ND power jack connector. 5.5 mm OD, 2.1 mm ID. Used on the Stimulator, JimStim, and DIYPNP to connect to a power supply.
Add to cartReplacement 4 position block for relay board injector power terminals.
Add to cart10-pack of wire jumpers in 5 colors. These fit 0.1" headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Add to cartBulkhead fittings, just like those included in our V2.2 kits and MapDaddy. It's made from black nylon, fits 1/8" vacuum line on both sides, and measures about 1 1/4" long. Use to replace broken fittings, or if you're running your MAP sensor or boost gauge...
Add to cart[3 Pack] Mica insulator / hardware kit for TO-220 components. Used for V3.0 / V3.57 Q9 and Q12, as well as for BIP373 coil drivers. Heat sink compound recommended. Includes 3 of each: mica insulators mounting screws nuts lockwasher i...
Add to cart1/8" vacuum Y-fitting, as included in the MSPNP and Mustang plug and play packages. This is made of clear polycarbonate. Maximum pressure 125 psi. This plastic is tough enough to take 275 degree F engine temps, and won't crack even if exposed to Siberian ...
Add to cart
Reviews
There are no reviews yet.