Cart

Quick Links

EGT Clamp and Fitting

EGT Clamp and Fitting

$16.49

-

Add to wishlist
SKU: EGT_0235 Categories: ,

Description

Attach an EGT probe to your exhaust without welding using this worm drive clamp and compression fitting. Fits 1.56″ to 2.5″ OD tube headers or exhaust pipes, with a 3/16″ compression fitting for use with our EGT probes. Made from stainless steel.

Customer reviews

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may write a review.

What size probe does this fit?

  • This fits a 3/16″ diameter probe.

When would this fitting be appropriate?

  • It is best to use this clamp on fitting for temporary installations in thin header tubes where you intend to plug the hole later with welding or a sheet metal screw. For cast iron manifolds, our threaded fitting would be a better fit, and we recommend using a weld in bung if you need a more permanent install.

Questions & Answers

There are no questions yet, be the first to ask something for this product.

Only registered users are eligible to enter questions

Related products

  • 50mm Optical Trigger Wheel for Nissan SR20DET or KA24DE

    5 out of 5
    $29.00

    Convert your Nissan CAS to a more MegaSquirt-friendly arrangement with our bolt-in 50mm Nissan Trigger wheel! This replaces the stock low-resolution Nissan trigger wheel that has four slits with a higher resolution 24-2 wheel crank trigger. Intended for u...

    Add to cart

  • EGT Port Cap Kit – Package of 3

     $11.49

    Removing your EGT probes? Seal the hole with these cap kits. Note: These will not fit our thread in fittings (EGT_0004). If using the thread in fittings, you will need to unscrew the fitting and replace with a 1/8" NPT pipe plug instead. They will fit ...

    Add to cart

  • RacePak Female Cable Vnet Terminator Cap

     $18.90

    End cap to seal off your RacePak Vnet wiring harness.

    Add to cart
  • Open Tip EGT Probe

    Open Tip EGT Probe Black Stinger

     $80.00

    Measure your exhaust gas temperature per bank or per cylinder with this open tip EGT probe. It is a K type thermocouple with an 8 foot lead. The open tip EGT probe reads slightly faster than an enclosed tip probe, but tends to wear faster in extreme heat ...

    Add to cart

  • 2 Wire VSS/Ignition Connector

     $15.00

    This 2 wire pigtail connector replaces GM part number 12101855. Used on a variety of applications, including some distribtutorless ignitions, vehicle speed sensors, and many chassis wiring locations. Please check mating connectors before ordering.

    Add to cart

  • Innovate PL-1 Pocket Logger – 3875

     $99.00

    The PL-1 is the latest in Innovate Motorsports’ line-up of products to allow for easy data logging of your MTS (Modular Tuning System) compatible product. Whether you have an LC-1 & SSI-4, MTX gauges, or any other combination of Innovate Motorsports...

    Add to cart