$18.90
-
End cap to seal off your RacePak Vnet wiring harness.
There are no questions yet, be the first to ask something for this product.
Attach an EGT probe to your exhaust without welding using this worm drive clamp and compression fitting. Fits 1.56" to 2.5" OD tube headers or exhaust pipes, with a 3/16" compression fitting for use with our EGT probes. Made from stainless steel.
Add to cart
IAC Pigtail (6") for Jeep Stepper Motor Idle Air Controllers This is the wiring pigtail to compliment DarkStar's IAC Valve body complete with detailed assembly instructions (it's super easy- basically just plug them in) so that you can color code the w...
Add to cart
Removing your EGT probes? Seal the hole with these cap kits. Note: These will not fit our thread in fittings (EGT_0004). If using the thread in fittings, you will need to unscrew the fitting and replace with a 1/8" NPT pipe plug instead. They will fit ...
Add to cart
Convert your Nissan CAS to a more MegaSquirt-friendly arrangement with our bolt-in 50mm Nissan Trigger wheel! This replaces the stock low-resolution Nissan trigger wheel that has four slits with a higher resolution 24-2 wheel crank trigger. Intended for u...
Add to cart
The CANEGT 8 Channel Thermocouple Interface allows you to monitor up to 8 K-type thermocouples AND up to 8 Innovate wideband devices over an Innovate Log Chain, and can transmit the data to a MegaSquirt-II, MegaSquirt-III, MicroSquirt, MSPNP, or MS3Pro o...
Read more
Add a crankshaft position sensor to your engine with our laser cut 36-1 crank trigger wheel. This trigger wheel is 6 3/4" in diameter and 1/8" thick, with a 1/2" diameter center hole (with plenty of room to enlarge it for larger crank bolts). The teeth ar...
Add to cart
Reviews
There are no reviews yet.