EGT Measuring Equipment at DIYAutoTune.com

EGT Measurement

Looking to measure exhaust gas temperature? We now carry a line of EGT measuring equipment, from the TC-4 thermocouple interface to temperature probes to the mounting hardware. All probes are a K-type thermocouple with a 8′ lead. The differences is that the “Black Stinger” probes have an open end for faster reaction time, while the “Red Avenger” probes have a closed tip for better protection.

Showing all 8 results

CANEGT 8 Channel Thermocouple Interface
5 out of 5
$378.69
The CANEGT 8 Channel Thermocouple Interface allows you to monitor up to 8 K-type thermocouples AND up to 8 Innovate wideband devices over an Innovate Log Chain, and can transmit the data to a MegaSquirt-II, MegaSquirt-III, MicroSquirt, MSPNP, or MS3Pro o...
Read more
Open Tip EGT Probe Black Stinger
$80.00
Measure your exhaust gas temperature per bank or per cylinder with this open tip EGT probe. It is a K type thermocouple with an 8 foot lead. The open tip EGT probe reads slightly faster than an enclosed tip probe, but tends to wear faster in extreme heat ...
Add to cart
Closed Tip EGT Probe Red Avenger
$78.00
Measure your exhaust gas temperature per bank or per cylinder with a longer lasting, closed tip EGT probe, a K type thermocouple with an 8 foot lead. The open tip probe reads slightly faster than a closed tip EGT Probe, but tends to wear faster in extreme...
Add to cart
Stainless Steel EGT Weld-In Compression Fitting
$15.00
Got a stainless steel exhaust? Here's what you need to install an EGT probe in it. Weld this compression fitting into your headers or exhaust pipe. It holds a EGT probe securely in place. Compression type fitting provides a leak-free seal that holds up at...
Add to cart
Stainless Steel EGT 1/8″ NPT Compression Fitting
$14.00
Need a weld-free way to add EGT fittings to a cast iron manifold? Drill and tap it for 1/8" NPT pipe thread and bolt one of these in! Works with our Red Avenger and Black Stinger thermocouples.
Add to cart
EGT Clamp and Fitting
$16.49
Attach an EGT probe to your exhaust without welding using this worm drive clamp and compression fitting. Fits 1.56" to 2.5" OD tube headers or exhaust pipes, with a 3/16" compression fitting for use with our EGT probes. Made from stainless steel.
Add to cart
EGT Port Cap Kit – Package of 3
$11.49
Removing your EGT probes? Seal the hole with these cap kits. Note: These will not fit our thread in fittings (EGT_0004). If using the thread in fittings, you will need to unscrew the fitting and replace with a 1/8" NPT pipe plug instead. They will fit ...
Add to cart